Plug adapters bear a letter corresponding to the plug configuration. Just clip the cover back into place and put the screws back in. Purchase a travel adapter to fit the electrical outlet for the country based on the type of plug or socket used. Step 9: replace the cover and screw it back on After you’ve pushed one into the screw hole, tighten that terminal screw back up. Push the wires into the connector hole one by one. Step 8: insert each wire, tightening after each is added Step 7: loosen the terminal screws in the US plugĭo the same as you did in the old plug, just loosen the screws a little. If you’ve bought a new plug, it should say which is which in the information you receive with it. Simply identify the terminals that match up with your wires. If that’s the case, you may just need to cap that wire. In some cases, US plugs may not have a ground terminal. Just follow the same steps, opening up the new plug you’re going to use. International Travel Adapter - Use any 240V International appliance with our international Inbound Travel Adapters. Step 6: open up your new US plug and identify your terminals. Don’t completely remove them, you just need to unscrew them until you can pull the 3 wires out of their connector holes. You’ll need that flat-headed screwdriver again, so grab it and loosen the screws on each of the terminals. Step 5: Loosen the terminal screws in the old plug and remove the wires If you have problems telling colours apart, you should label each wire as you remove it with some tape, as the terminal it’s currently in will help you identify the wire. The wires going into each terminal also correspond to the job the wire is doing. The hot terminal should have a fuse connected to it. When looking directly at the plug, the three wires are: This will then reveal the 3 wires and the terminals they connect to. Once you’ve taken out the screw, you just need to take the cover off. Step 3: remove the back cover of the plug and identify the terminals In some instances, there may be 2 small screws in addition to the main screw. Grab your flat head screwdriver and remove the screw that holds the back of the plugin place. Then you need to remove the wires from the old plug and attach them to this new plug. Make sure it’s one that’s compatible with the device you’re attaching it to. You should be able to find one of these online or at your local hardware store. You’ll need to buy a plug that fits an American plug socket. Disclaimer: opening up plugs may void your warranty and if you don’t re-wire them properly you could cause damage to your device or harm to yourself.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |